Meals on wheels conversion 

Operating / Working the Oven

Regn Electric (Electric use only 120 Degrees setting) Regn Diesel (95 Degrees setting) Road Diesel (75 Degrees setting)

1. Turn on the oven prior to loading on all operations.

2. Oven on Diesel to be turned on to the Regenerating position (Regen Diesel).

3. Put food into the oven when satisfied with the pre-heated temperature.

4. Load the food into the oven to regenerate to your preferred core temperature.

5. When the core temperature has been achieved, switch the oven to its holding temperature position (Road diesel).

Switching operation from Diesel Regen to Road Diesel

1. Important: Switching the oven from regeneration to holding, you must have both switches (Regen Diesel and Road Diesel) in the "on" position.

2. When both switches are in the "on" position, the displays on both controls will read unusual figures. When the figures have settled, turn off the Regenerating switch and leave the Road Diesel on. The controller on the Road Diesel will change back to the oven temperature.

3. Switching to Road Diesel will allow the oven to cycle at 75 degrees centigrade +/-2 degrees.

4. If at any time you wish to return the oven to Regenerating temperatures (increase food temperature), repeat the above procedure and turn off the Road Diesel holding temperature switch.

If the above procedures are not followed, the oven will automatically go into a safety mode and will not heat for approximately 15-20 minutes.

When you have finished with your last delivery, turn off whichever switch you have on.

Electric operation

1. Plug the power lead into the side of the vehicle, lifting up the white flap.

2. Switch on Regen Electric. You will see at this stage two controllers will display the oven temperature.

3. The oven temperatures are preset to 120 degrees centigrade, and when the air temperature has been achieved, the ovens will cycle on a 2-degree differential.

4. When changing over from electric to diesel, you must pull out the standby lead and turn off the electric switch before turning on any of the diesel switches.

5. Before driving away, please ensure you have disconnected the 240-volt lead from the vehicle.

Important: Monitor the temperatures on electric so you do not overheat the food.

On all operations, when finished, turn off all switches.